If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
scan disc, disc defrag will not run
I have had problems running system tools disc defrag and
scan disc when I run it a mesage pops up saying that a program is running and writting to selected drive eve if I check for any running programs. alt ctrl del only explore running |
#2
|
|||
|
|||
Have a look here, by MS MVP Ron Badour:
http://home.satx.rr.com/badour/html/scandisk.html and http://home.satx.rr.com/badour/html/defrag.html Here is a little utility to automate it for you: GEODisk by MS MVP George Gedye http://mvps.org/PracticallyNerded/Software.htm -- Glen Ventura, MS MVP W95/98 Systems http://dts-l.org/goodpost.htm "kevin" wrote in message ... I have had problems running system tools disc defrag and scan disc when I run it a mesage pops up saying that a program is running and writting to selected drive eve if I check for any running programs. alt ctrl del only explore running |
#3
|
|||
|
|||
http://support.microsoft.com/default...;EN-US;q287914
Articles about Scandisk http://support.microsoft.com/default...;en-us;Q286263 Articles about Defrag I must warn that Scandisk may not do a great job when there is a great one to do... http://cquirke.mvps.org/9x/scandisk.htm Therefore, perhaps UNcheck "Automatically fix errors" on it's front screen. It will then ask whether you want each error fixed. If it sounds truly horrible, say "No!", and post the log. The log will be "C:\Scandisk.log". Do not let it constantly restart, either. 1. Turn off screen saver (R-Clk Desktop, Properties, Screen Saver-- None) 2. Turn off power management (Control Panel, Power Management-- Always On,Never,Never,Never) 3. Disable any permanent internet cable connection, perhaps. 4. Suspend Task Scheduler 5. Turn off interfering programs. Use "StartupCop" or "EndItAll2" from PCMag (below). Or "START, Run, MSConfig, Startup tab". Note what is unchecked. Then, go to the General tab & disable the entire Startup Group, by clicking "Selective.." & unchecking "Load Startup...". Reboot. Don't forget to re-enable before the next boot. 6. Use "HDValet" from PCMag, or (a) "Control Panel, Internet Options, Delete Files button, bolt Delete all offline content, OK, OK" (b) "START, Run, %TEMP%", & delete all files that will let you. This will likely be "C:\Windows\Temp". This is best done after a fresh boot, unless you have not seen the message "Reboot to complete this install". 7. Run Scandisk (Thorough, usually w/o write testing. Check all three items under "Scandisk, Advanced button, 'Check files for' box". If you want to be informed as it does a fix, UNcheck "Automatically fix errors" on the front screen, or look inside "C:\Scandisk.log" afterwards.) 8. "START, Run, Defrag /p /details". Apparently, "/p" Defrags the unmovables. The purpose of steps 1-5 is only to prevent constant restarts of Scandisk & Defrag, if you get them; but DEFINITELY turn off the Virus Scanner. Scandisk should be done perhaps once a month, and certainly after every serious crash. Do a Defrag after a sluggish boot or when this says so: http://www.pcmag.com/ 's CrackUp, by Gregory A. Wolking & Bob Flanders. Also, take DiskAction, to determine what is constantly writing to the HDD, which causes the restarts. Take BHOCop & StartupCop too. "DiskAction" reports the last 12 processes that access any partition. It discovered the MS Critical Update Notification Tool was accessing my HDD every five minutes. It can be uninstalled in "Control Panel, Add/Remove Programs". Then, occasionally, "START, Windows Update" on your own. "BHOCop" found a Browser Helper Object called Wavehelper Class, created by "Wavetop", that was building a monstrosity of an error log called "Logit.txt" in here. "START, Find, F/F, Logit.txt"-- see one? Now, my hard drive is quieter than my mouse. (Of course, I now also have 384 MB RAM, up from an initial 64, eliminating Swap File activity.) -- Thanks or Good Luck, There may be humor in this post, and, Naturally, you will not sue, should things get worse after this, PCR "kevin" wrote in message ... | I have had problems running system tools disc defrag and | scan disc when I run it a mesage pops up saying that a | program is running and writting to selected drive eve if I | check for any running programs. alt ctrl del only explore | running |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Scan Disc | jj | General | 6 | September 18th 04 03:40 PM |
scan disc | jj | General | 0 | September 17th 04 01:31 PM |
defrag and scan disc problems | joan | General | 2 | July 21st 04 03:34 PM |
scan disc and defrag | kellyc | Improving Performance | 5 | May 20th 04 07:20 PM |
scan disc and defrag | kellyc | Improving Performance | 1 | May 11th 04 12:26 AM |