If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
RAM
After the installation of 128 Mb of RAM,to reach 256 Mb,I fund this line in
Autoexec.bat: if Exist C:\Drivers\HDprep\HDPREPEZ.bat call c:\Drivers\HDprep\HDPREPEZ.bat and,when I am not connected,at the computer start,I have 4 messages: RPCSS has caused an error of invalid page fault in the module unknown in..... I tried to remove the new memory stick,but it's always the same. Somebody knows what have I to do? Thank you |
#2
|
|||
|
|||
john wrote: After the installation of 128 Mb of RAM,to reach 256 Mb,I fund this line in Autoexec.bat: if Exist C:\Drivers\HDprep\HDPREPEZ.bat call c:\Drivers\HDprep\HDPREPEZ.bat and,when I am not connected,at the computer start,I have 4 messages: RPCSS has caused an error of invalid page fault in the module unknown in..... I tried to remove the new memory stick,but it's always the same. Somebody knows what have I to do? Thank you This is a laptop, right? HDPREPEZ (or HDPREP) prepares your machine for "hibernation" by reserving an area on the disk to store the contents of the RAM (plus a few other things). When the RAM size changes, you need to run HDPREP to change the size of the reserved area. Sounds like it's working like it's supposed to. RPCSS is a Windows service that lets other computers run things on your computer. It's important in some network environments, usually large corporate networks, but if this is you personal machine, it probably should be disabled (it's enabled by default). See http://www.cert.org/advisories/CA-2003-23.html for a warning about a vulnerability in RPCSS and what to do about it. I don't see that it has anything to do with your new RAM, unless somebody changed some Windows settings at the same time. Possibly a file RPCSS depends on got damaged when the computer was shut off improperly, or for some other reason. When Windows sees you're trying to connect, it tries to load it and fails with the message you gave. Alternately, some sort of virus, worm, or spyware may have damaged it, or changed the registry code that loads it, or even be pretending to be it. If you haven't, check you computer with at least two different virus checkers and two or more spyware checkers. There are free and online versions of both available. You can Google for HDPREPEZ or for RPCSS and find quite a bit of information; you can also got to Microsoft's support site and check the "Knowledge Base". Good luck. |
Thread Tools | |
Display Modes | |
|
|