|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 7th 04, 07:11 PM
|
|||
|
|||
Power Defrag 3.01 Problem - HELP
I haven't defragged in about 4 months, I guess, but have used Power Defrag
3.01 for a while as I never could defrag without it - constant restarting and never finished the defrag. I have Windows 98SE. I was just trying to use it and received the following message in a pop-up window '429 ActiveX component can't create object'. I tried again and received '91 Object Variable or With block variable not set'. I clicked OK and then was told "Power Defrag has finished'. What have I done now? Yikes, I have no idea what any of that means. Please help. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| power problem | RB | General | 6 | September 26th 04 02:48 AM |
| Hardware, software or power surge problem? | Sybil Fox | General | 8 | August 27th 04 08:08 PM |
| defrag problem | eshine | Improving Performance | 4 | June 20th 04 10:31 AM |
| Power problem?! | Dave | Hardware | 5 | May 31st 04 08:56 PM |
| defrag problem | Hardware | 0 | May 6th 04 03:46 AM | |
Linear Mode
