A Windows 98 & ME forum. Win98banter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » Win98banter forum » Windows 98 » Setup & Installation
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

Windows will not fully load



 
 
Thread Tools Display Modes
  #1  
Old October 31st 04, 05:06 PM
Terri Creagh
external usenet poster
 
Posts: n/a
Default Windows will not fully load

I have an older computer on which Win98 is running. This system basically
crashed after an attempt to re-install a printer that was giving me a
problem. I have tried re-installing Win98 from the CD that came with my
IBM computer, but I get a message saying that I already have an upgraded
version of Win98 on my computer, and it will not re-install. Presumably,
this has something to do with my having installed the service packs for
Win98. I have run scandisk successfully. However, when I boot into Windows
safe mode, I get the "program has performed an illegal operation and will be
shut down" error message with the following details:



EXPLORER caused an invalid page fault in

Module EXPLORER.EXE at 0177:00401f31

Registers:

EAX=00000000 CS=0177 EIP=00401f31 EFLGS=00010246

EBX=00000001 SS=017f ESP=0080ffic EBP=0080ff24

ECX=c156a1c0 DS=017f ESI=00000000 FS=27ef

EDX=0080ff2c ES=017f EDI=00000000 GS=0000

Bytes at CS:EIP:

86 08 50 ff 11 8b 45 08 50 8b 08 ff 51 08 8b
45

I have tried to create a FAT32 EBD by running FAT32EBD from the Windows 98
CD. However, when I get to the stage of "Insert diskette into A drive -
Warning: all info on diskette will be erased. Press ' Y 'to continue or any
other key to exit. " I enter ' Y ' and then I get into a loop where the
program just keeps asking if I want to continue.



I do not want to upgrade this computer to any higher Windows version right
now for a lot of complicated reasons. Reformatting is not an option,
because I have some very valuable data on this computer. Of course, I have
backups, but reconstructing the database would be a huge effort. Does
anyone have suggestions as to what I might do?

Thank you.


  #2  
Old October 31st 04, 05:41 PM
glee
external usenet poster
 
Posts: n/a
Default

Do you get the same illegal operation error message and details, in both normal and
safe modes? Do you get to the Desktop? How far into startup do you get?

Try the procedures here -
Recovering From a Failed Internet Explorer Upgrade in Windows 98:
http://www.cs.bsu.edu/~gjjones/admin...nd ows98.html
or
http://tinyurl.com/r5ba

Especially this section at the end:

"If you still have boot problems after you reboot, you should use the command prompt
to edit the c:\windows\system.ini file. On the command line type edit
c:\windows\system.ini.

"Once it is open, change the line shell=explorer.exe to shell=progman.exe. What you
are doing here is changing the default shell (that is having problems) from the
Windows Explorer to the old Windows Program Manager shell.

"Reboot Windows. It should now successfully boot with no errors into an empty
Program Manager shell. Use the File | Run | Browse drop down menu selection to
browse to c:\program files\internet explorer and launch ie5setup.exe or ie6setup.exe
(depending on what is there). Do a custom install and check all the Bold faced
options. When the setup program alerts you that these files are already installed,
tell it to reinstall all of the files.

"When the Internet Explorer Setup program is done and reboots, hit the F8 key to
bring up a Boot Menu. Choose Command Prompt and boot to the command prompt. Once
there, type edit c:\windows\system.ini and, once it is open, change the line
shell=progman.exe back to shell=explorer.exe. Save and exit the file. You have now
set the shell back to the original value."
--
Glen Ventura, MS MVP W95/98 Systems
http://dts-l.org/goodpost.htm


"Terri Creagh" wrote in message
link.net...
I have an older computer on which Win98 is running. This system basically
crashed after an attempt to re-install a printer that was giving me a
problem. I have tried re-installing Win98 from the CD that came with my
IBM computer, but I get a message saying that I already have an upgraded
version of Win98 on my computer, and it will not re-install. Presumably,
this has something to do with my having installed the service packs for
Win98. I have run scandisk successfully. However, when I boot into Windows
safe mode, I get the "program has performed an illegal operation and will be
shut down" error message with the following details:



EXPLORER caused an invalid page fault in

Module EXPLORER.EXE at 0177:00401f31

Registers:

EAX=00000000 CS=0177 EIP=00401f31 EFLGS=00010246

EBX=00000001 SS=017f ESP=0080ffic EBP=0080ff24

ECX=c156a1c0 DS=017f ESI=00000000 FS=27ef

EDX=0080ff2c ES=017f EDI=00000000 GS=0000

Bytes at CS:EIP:

86 08 50 ff 11 8b 45 08 50 8b 08 ff 51 08 8b
45

I have tried to create a FAT32 EBD by running FAT32EBD from the Windows 98
CD. However, when I get to the stage of "Insert diskette into A drive -
Warning: all info on diskette will be erased. Press ' Y 'to continue or any
other key to exit. " I enter ' Y ' and then I get into a loop where the
program just keeps asking if I want to continue.



I do not want to upgrade this computer to any higher Windows version right
now for a lot of complicated reasons. Reformatting is not an option,
because I have some very valuable data on this computer. Of course, I have
backups, but reconstructing the database would be a huge effort. Does
anyone have suggestions as to what I might do?

Thank you.



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
can't access .pif Ron Jacob General 13 September 7th 04 03:23 AM
FAQ: Win98 users: Upgrading to WinXP, IE6, etc. JM Improving Performance 6 July 26th 04 01:44 PM
Microsoft Security Bulletin MS04-024 - Vulnerability in Windows Shell Could Allow Remote Code Execution (839645) Gary S. Terhune General 2 July 14th 04 05:06 AM
deleted explorer.exe Anida Software & Applications 20 June 16th 04 06:21 AM
Windows doesn't load Doug Software & Applications 1 May 6th 04 05:15 AM


All times are GMT +1. The time now is 04:52 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 Win98banter.
The comments are property of their posters.