|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 1st 05, 11:54 AM
|
|||
|
|||
Optimum IDE Settings
Hi,
My current set up is 3 hard drives plus a cd-rom. The operating system and one disk for storage is connected to the primary channel.The second channel is set-up as Master = CD-Rom Slave = Hard Disk for storage I am replacing the CD-Rom for a combination drive CD-DVD is it best to have this set as the Master or Slave ? Regards Chris 
|
|
#2
June 1st 05, 09:12 PM
|
|||
|
|||
|
"Chris" wrote:
Hi, My current set up is 3 hard drives plus a cd-rom. The operating system and one disk for storage is connected to the primary channel.The second channel is set-up as Master = CD-Rom Slave = Hard Disk for storage I am replacing the CD-Rom for a combination drive CD-DVD is it best to have this set as the Master or Slave ? Regards Chris I would put the hard drive as the master on the secondary IDE and the combo CD-DVD drive as slave. Good luck Ron Martell Duncan B.C. Canada -- Microsoft MVP On-Line Help Computer Service http://onlinehelp.bc.ca In memory of a dear friend Alex Nichol MVP http://aumha.org/alex.htm
|
|
#3
June 4th 05, 07:56 AM
|
|||
|
|||
|
Ron Martell wrote:
"Chris" wrote: Hi, My current set up is 3 hard drives plus a cd-rom. The operating system and one disk for storage is connected to the primary channel.The second channel is set-up as Master = CD-Rom Slave = Hard Disk for storage I am replacing the CD-Rom for a combination drive CD-DVD is it best to have this set as the Master or Slave ? Regards Chris I would put the hard drive as the master on the secondary IDE and the combo CD-DVD drive as slave. Good luck Ron Martell Duncan B.C. Canada Thanks Ron, it works fine
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tough one: Display settings won't save in Windows 98 | [email protected] | General | 3 | January 17th 05 08:12 AM |
| An unexpected "System Settings Change" | Stan Hilliard | General | 3 | January 12th 05 04:49 AM |
| Printer Time Out Settings | Ray Pixley | General | 8 | December 20th 04 09:14 PM |
| ActiveX settings | Wade Koehn | Monitors & Displays | 0 | July 21st 04 04:54 PM |
| Put Documents and Settings on D partition? | Clark G | General | 1 | June 11th 04 06:01 AM |
Linear Mode
