|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 2nd 04, 01:29 AM
|
|||
|
|||
Partioned 40g.disc 20/10/10,was finished reached forEsc and hit?
Pute rebooted ....no A, or C prompt, just a blinking line
|
|
#2
June 2nd 04, 01:34 AM
|
|||
|
|||
|
Partioned 40g.disc 20/10/10,was finished reached forEsc and hit?
Did you format the partitions you created? I would run fdisk again since
you don't know what key you hit. -- Regards Ron Badour, MS MVP for W98 Tips: http://home.satx.rr.com/badour Knowledge Base Info: http://support.microsoft.com/default.aspx?pr=kbinfo "Mike" wrote in message ... Pute rebooted ....no A, or C prompt, just a blinking line
|
|
#3
June 2nd 04, 09:31 PM
|
|||
|
|||
|
Partioned 40g.disc 20/10/10,was finished reached forEsc and hit?
No mention of formatting. No mention of tool to make these partitions
either. So, any answer is inappropriate until that information is gathered. Not saying you're wrong, Ron. Just saying this may be one slinking under the bridge. "Ron Badour" wrote in message ... Did you format the partitions you created? I would run fdisk again since you don't know what key you hit. -- Regards Ron Badour, MS MVP for W98 Tips: http://home.satx.rr.com/badour Knowledge Base Info: http://support.microsoft.com/default.aspx?pr=kbinfo "Mike" wrote in message ... Pute rebooted ....no A, or C prompt, just a blinking line
|
|
#4
June 2nd 04, 09:37 PM
|
|||
|
|||
|
Partioned 40g.disc 20/10/10,was finished reached forEsc and hit?
Hi Dave,
He included most of the info in the title of the post. Since he created partitions and tried to hit Esc to end the session, I concluded he was using fdisk. -- Regards Ron Badour, MS MVP for W98 Tips: http://home.satx.rr.com/badour Knowledge Base Info: http://support.microsoft.com/default.aspx?pr=kbinfo "Lil' Dave" wrote in message news:XOqvc.6695$Y21.6145@lakeread02... No mention of formatting. No mention of tool to make these partitions either. So, any answer is inappropriate until that information is gathered. Not saying you're wrong, Ron. Just saying this may be one slinking under the bridge. "Ron Badour" wrote in message ... Did you format the partitions you created? I would run fdisk again since you don't know what key you hit. -- Regards Ron Badour, MS MVP for W98 Tips: http://home.satx.rr.com/badour Knowledge Base Info: http://support.microsoft.com/default.aspx?pr=kbinfo "Mike" wrote in message ... Pute rebooted ....no A, or C prompt, just a blinking line
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
