If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
run scanreg /fix and cannot seem to boot into command prompt
I need to run scanreg /fix and cannot seem to boot into command prompt to do
so. Can anyone help? Windows crashed and is trying to search for new hardware with the "Add New Hardware Wizard" due to a registry error whereas there is not enough room on disk to load registry fully. What should I do? Does anyone know what drivers I should direct the search to look for? I would appreciate any help that I can get to resolve this issue. Thanks in advance. -- ~Dell -spam-please |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Command Prompt | Chris | General | 4 | September 25th 05 04:14 AM |
help!!! can only boot to command prompt only (corrupt files) | korvorka | General | 2 | April 30th 05 02:48 AM |
Can not get command prompt | Dhuri | General | 3 | December 11th 04 10:59 PM |
Command prompt | CMAR | Setup & Installation | 0 | October 1st 04 06:28 PM |