A Windows 98 & ME forum. Win98banter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » Win98banter forum » Windows ME » Setup & Installation
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

New PC, ME with old BIOS



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old April 4th 08, 04:19 PM posted to microsoft.public.windowsme.setup
William B. Lurie
External Usenet User
 
Posts: 60
Default New PC, ME with old BIOS

Okay, fellers.... I'll remove the "?" devices
in Safe Mode and reboot, and see if it finds
enough to proceed to Normal Mode. And thanx.

Mart wrote:
William asked :-

What's your next advice? Shall I try to remove the devices
with the yellow question marks?


Yes, the fact that the HDD is not in its 'native' environment would mean
that any hardware (previously) detected and installed will have the drivers
etc., setup for the original PC on the HDD.

The 'new' PC may have *similar* devices, but not exactly the same so those
original drivers are probably unsuitable, but perhaps not sufficiently so
for the newly run PC to want to install fresh drivers. The clue is probably
the "PCI Multimedia Device" - possibly a sound card.

However, the 'solution' as you already suggested, is to 'Remove' ALL the
items you listed in Device Manager (using Dev.Man) - which you must do in
Safe Mode. Then re-boot and let WinMe re-detect and install NEW drivers (You
might be called on to supply the appropriate drivers as WinMe (re-)detects
the 'new' hardware, so you might need any driver disks/CD's supplied with
the 'new' PC)

Hopefully, that will get you past the "flashing 'dash' prompt" you mentioned
in your reply to Zee and good luck.

Mart


"William B. Lurie" wrote in message
...
Okay, Mart, I went thar and looked again. In Device Manager,
there are *no* Exclamation Points or errors, but down in
"Other Devices" there are 3 yellow question marks....one
at PCI Multimedia Device. and one each at USB device.

I did full system scandisk including surface check, with
no errors found.

What's your next advice? Shall I try to remove the devices
with the yellow question marks?

Mart wrote:
Besides Zee's most important question, when in Safe Mode take a look in
Device Manager and make a note of any/all errors, conflicts and multiple
entries (especially modems, video or sound cards and their drivers).
Might just reveal a potential hardware issue.

Mart



"oops!!" wrote in message
...
William,

What happens exactly when you start Windows in Normal Mode?

Zee



"William B. Lurie" wrote in message
...
That's the best I can describe it.
I have a hard drive from my old PC
with ME on it. It won't boot in Normal
Mode in my new PC, I suspect because
it was mad with a different BIOS.

However, it boots just fine in Safe Mode.
Is there a way to get around this?
(I hope I made it clear enough).
Thanks.


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
BIOS upgrades - reflashing the BIOS Bill in Co. General 21 March 25th 08 10:22 PM
BIOS Sean New Users 3 March 27th 05 07:30 PM
BIOS Sean Hardware 0 March 5th 05 07:27 AM
bios help elocm General 4 November 12th 04 09:26 PM
bios shep Setup & Installation 3 July 14th 04 09:17 PM


All times are GMT +1. The time now is 02:28 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 Win98banter.
The comments are property of their posters.