|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 31st 04, 03:05 AM
|
|||
|
|||
Win98 Preptool
Could someone please tell me the location of the Win98
drive image tool called preptool. I have looked in the Reskit on the cd for the tool and cannot locate it. I have googled many times and find others looking for it but i find nothing. I have wanting to implement Win98 into my RIS server, so in this case I cannot use Ghost or DriveImage. Any help would be greatly appriciated. Thanks Phillip 
|
|
#2
December 31st 04, 10:11 PM
|
|||
|
|||
|
Hi Phillip,
As far as I can tell it is included in the OEM Pre-installation kit and is not available for download. See this link for more information for System Builders. http://www.microsoft.com/oem/main.asp -- Regards, Bert Kinney [MS-MVP DTS] http://dts-l.org/ Phillip wrote: Could someone please tell me the location of the Win98 drive image tool called preptool. I have looked in the Reskit on the cd for the tool and cannot locate it. I have googled many times and find others looking for it but i find nothing. I have wanting to implement Win98 into my RIS server, so in this case I cannot use Ghost or DriveImage. Any help would be greatly appriciated. Thanks Phillip
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Win98 re-install | Terri Creagh | General | 3 | October 12th 04 03:03 AM |
| Remove Win98 CAB folders ? | Doc | General | 1 | June 28th 04 12:18 PM |
| Too Fast for Win98? | BC | General | 7 | June 9th 04 09:09 AM |
| How do I print to TCPIP connected printer from Win98? | Al Dykes | Networking | 0 | June 6th 04 04:13 PM |
| win98 boot disk | shawn | Disk Drives | 6 | May 28th 04 01:06 PM |
Linear Mode
