If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bad Hard drive or doing something wrong?
I bought a used Seagate Medallist 8641 St38641A 8 GB hard drive on
ebay. I installed it in a Compaq Presario 5204 desktop machine. Partitioned it with Seagate's latest edition of Disc Wizard on two floppies made from a download from their site. All was going well got windows 98SE on it and it booted but as soon as I started putting applications back on it and restarting between each install at about 212 MB of data on it, it failed to boot. Redid it all again and the same thing happened. So I put my old 4 GB Seagate that came with the machine back in and reset the jumpers on the 8 GB to non on for slave and as my computer manual says also set a jumper to cable select to set and put it in the slave position. Did the partition and reformat with disk wizard. Started to load more applications on it and somewhere along the line it gave me a warning at restart that the disk may be damaged. It ran scan disk I guess in the blue screen DOS mode and when it gets to cluster 121,289 about of a total clusters or 1,048,864 it slows to a ridiculous crawl. And starts to say that portion of the disk is bad and locks out for use that section and I guess moves the data to a new area of the disk. However this is continuing on cluster by cluster and I ran it all night maybe 15 hours and it got to cluster 150,000 (something) and is still locking out the areas as bad. Now With Seagate's disk Wizard it installed Dynamic Disk Overlay to I guess both hard drives in order to see the full 8GB of the slave. I believe way back at first when I tried to use the drive as the primary it only saw like 2.1 GB of the drive until I ran the Disc Wizard application. The question in all this is do you think I have a bad hard drive somewhere at 200 MB and beyond or is it that the computer being a 1998-99 manufactured motherboard still can not use the larger capacity. In my computer folder set to view as web page it show 8 GB for the size for it. I have purchased a few used IDE 8 to 10 GB drives on ebay that are on the way do you think I will run into the same problems. And will or should I use Seagate's application to partition and install the DDO again. One is a Quantum fireball with is now supported by Maxtor, which is owned by Seagate as the information I see on line about who owns and supports who. Am I basically doing something wrong? Have I missed a step or done a redundant conflicting thing? Or do I just maybe have a bad Hard Drive? One more sideline question of many and it only happens when I am not doing anything to or on the slave but I hear it spin down to off is that normal for a slave? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adding new hard drive for backup | CdLSRN | General | 3 | November 19th 06 08:05 PM |
win 98 installation | rc | General | 21 | September 6th 06 09:04 PM |
Primary IDE Controller Error | Mathers | General | 51 | August 5th 06 12:22 AM |
Adding extra hard drive | Jonny | General | 23 | January 10th 06 11:55 PM |
cd rom drive disappears when I install a new hard drive ??? | Edward Letendre | Disk Drives | 5 | February 16th 05 12:55 AM |