If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Removing second hard drive
I now have two 4g hard drives. Want to remove one of
them. Every time I disconnect the hard drive I can not boot the computer. Wants a disk to boot. Have changed the BIOS and fdisk the second hard drive. Computer shows no hard drive, but also show the primary as disabled. Help |
#2
|
|||
|
|||
Removing second hard drive
In order to boot from a hard drive it must be set as active using FDISK. My
guess is the one you disconnect is the active one. You'll have to boot from a floppy, run FDISK, make the one you want to boot from active (and make sure the boot files are on it), reboot and it should boot. "Car" wrote in message ... I now have two 4g hard drives. Want to remove one of them. Every time I disconnect the hard drive I can not boot the computer. Wants a disk to boot. Have changed the BIOS and fdisk the second hard drive. Computer shows no hard drive, but also show the primary as disabled. Help |
#3
|
|||
|
|||
Removing second hard drive
If the drives are Western Digital then there must not be a jumper at all for
a single drive. "Herbert West" wrote in message ... On Sat, 19 Jun 2004 20:40:49 -0700, "Jerry" wrote: In order to boot from a hard drive it must be set as active using FDISK. My guess is the one you disconnect is the active one. You'll have to boot from a floppy, run FDISK, make the one you want to boot from active (and make sure the boot files are on it), reboot and it should boot. Also: There are "master" and 'Slave" jumpers at the rear of each hard drive. If only one drive is attached, it must be set to "Master" or the computer won't boot. "Car" wrote in message ... I now have two 4g hard drives. Want to remove one of them. Every time I disconnect the hard drive I can not boot the computer. Wants a disk to boot. Have changed the BIOS and fdisk the second hard drive. Computer shows no hard drive, but also show the primary as disabled. Help |
#4
|
|||
|
|||
Removing second hard drive
-----Original Message----- If the drives are Western Digital then there must not be a jumper at all for a single drive. The single drive MUST use the plug on the END of the IDE bus cable. The plug further down the cable is for the second (slave) drive. Good Luck. BarryG |
#5
|
|||
|
|||
Removing second hard drive
Yep, a single drive is neither a master nor a slave.
"BarryG" wrote in message ... -----Original Message----- If the drives are Western Digital then there must not be a jumper at all for a single drive. The single drive MUST use the plug on the END of the IDE bus cable. The plug further down the cable is for the second (slave) drive. Good Luck. BarryG |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cloning Hard Drive | damo | General | 1 | July 15th 04 11:16 PM |
Secondary Hard Drive | Brad L | Hardware | 17 | June 14th 04 04:03 PM |
Zero-byte D: drive should not show, C: missing from Device Manager | *Vanguard* | General | 8 | June 12th 04 04:19 AM |
Large Hard Drive & BIOS upgrade problems | Lago Jardin | General | 17 | June 11th 04 07:27 PM |
New 120 GIG Hard Drive: Garbled Folder appeared | Lago Jardin | General | 19 | May 28th 04 08:24 PM |