If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Old lotus and Win98
I have an old copy of Lotus123 V2.2 that I want to run within windows 98.
If I boot up in dos mode, lotus runs, but if I boot to windows and use a dos prompt, lotus goes directly to some search function so that calling up the lotus menu by using the "/" key will not work. Obviously the win98 operating system cannot be running at the same time as lotus for some reason. Any suggestions are appreciated. I can always use two computers to extract the data I need, but a fix would make life easier. |
#2
|
|||
|
|||
Old lotus and Win98
"bg" wrote in message ...
I have an old copy of Lotus123 V2.2 that I want to run within windows 98. If I boot up in dos mode, lotus runs, but if I boot to windows and use a dos prompt, lotus goes directly to some search function so that calling up the lotus menu by using the "/" key will not work. Obviously the win98 operating system cannot be running at the same time as lotus for some reason. Any suggestions are appreciated. I can always use two computers to extract the data I need, but a fix would make life easier. 1. Some DOS apps must be correctly installed from their source disks, i.e. do not behave OK if simply copied from another hard drive. 2. You ought to be able to configure Lotus 2.2 to run in a Win98 DOS box, if necessary by setting special AUTOEXEC or CONFIG parameters (done via the Lotus EXE's / Properties.) Your main difficulty will be printing to a Windows printer, soluble if Lotus can instal one of the DM printers your Windows printer can emulate. -- Don Phillipson Carlsbad Springs (Ottawa, Canada) |
#3
|
|||
|
|||
Old lotus and Win98
Open a DOS session from within Windows then install Lotus then run it.
-- Jeff Richards MS MVP (Windows - Shell/User) "bg" wrote in message ... I have an old copy of Lotus123 V2.2 that I want to run within windows 98. If I boot up in dos mode, lotus runs, but if I boot to windows and use a dos prompt, lotus goes directly to some search function so that calling up the lotus menu by using the "/" key will not work. Obviously the win98 operating system cannot be running at the same time as lotus for some reason. Any suggestions are appreciated. I can always use two computers to extract the data I need, but a fix would make life easier. |
Thread Tools | |
Display Modes | |
|
|