If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
spool32 error
I've looked at other methods to fix this, but they don't
seem to apply or work. First off, I installed a new HP printer and shortly after that I would get error messages such as: Spool32 has caused an error in KERNEL.dll or Spool32 has caused an error in unknown. I uninstalled my old printers drivers, didn't help. Booted up in safe mood/clean boot and even then I would often get the spool32 error box to show up. I went into my spool folder and found nothing in the PRINTERS folder. I cleaned out the TEMP folder. Still getting the same error on startup. I can't print if I close the error box that shows up on startup. The error box shows up when I want to open my Printers folder in my Control Panel. I've tried printing directly to the printer. I've ran out or tried just about all the possible solutions I have seen. The error box shows up everytime I boot and am ready to use my PC. Thanks in advance for your help. |
#2
|
|||
|
|||
See if anything here helps.
Joan SPOOL32 problems Troubleshooting Spool32 Error Messages [Q191949] http://support.microsoft.com/support.../q191/9/49.asp OL98: "SPOOL32 Caused an Invalid Page Fault in Kernel32.dll" [Q247821] http://support.microsoft.com/support.../q247/8/21.asp Lux wrote: I've looked at other methods to fix this, but they don't seem to apply or work. First off, I installed a new HP printer and shortly after that I would get error messages such as: Spool32 has caused an error in KERNEL.dll or Spool32 has caused an error in unknown. I uninstalled my old printers drivers, didn't help. Booted up in safe mood/clean boot and even then I would often get the spool32 error box to show up. I went into my spool folder and found nothing in the PRINTERS folder. I cleaned out the TEMP folder. Still getting the same error on startup. I can't print if I close the error box that shows up on startup. The error box shows up when I want to open my Printers folder in my Control Panel. I've tried printing directly to the printer. I've ran out or tried just about all the possible solutions I have seen. The error box shows up everytime I boot and am ready to use my PC. Thanks in advance for your help. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problems with Spool32 invalid page fault at startup -module unknown | herm | General | 11 | April 17th 05 06:04 PM |
Error Messages | Greg Hall | General | 1 | July 27th 04 10:41 AM |
"Windows Protection Error", "VCACHE", problems booting and crashin | Kyan M. | General | 4 | July 17th 04 07:56 PM |
error messages | brnfrdmom | Software & Applications | 4 | July 5th 04 08:22 PM |
Internet explorer error in ME | ead | New Users | 1 | June 12th 04 04:08 PM |