Help required in interpreting the 'Timeout' field in parallel port's EPP mode.

Hi All,
I am working on the parallel port and need some help with the EPP mode
of operation. I am referring to a copy of "Parallel Port Complete" by
Jan Axelson as well as a copy of the IEEE 1284-1994 spec.

I have a couple of issues that I need some help with:

1. As given on page 270 of "Parallel Port Complete", the timeout
measurement in case of an EPP mode address-write cycle starts at the
falling edge of nIOW (which is a signal on the ISA interface) and ends
at the rising edge of nWait.

Nowhere in the spec have they mentioned this timeout duration.

Can someone please tell me that apart from the nIOW signal, can the
timeout measurement start at the toggling of any other signal on the
parallel port's interface itself (signals which are a part of the
parallel interface, and not on some bus like ISA) ?

Put another way, is there any method to measure this timeout duration
by watching a(ny) signal(s) on the port itself ?

2. The book (Axelson) says that when a EPP timeout is detected, the 0th
bit in the Status register (S0) is set to 1 (presumably by the port's
hardware). I wish to know how is the status of this bit known to the
host, i.e., is there any interrupt generated when the S0 bit is set, or
is there any polling mechanism by the associated driver software ?

If someone could give me some insight in these issues, I'd be really
grateful.

Best regards,
Amit.