|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 7th 04, 12:11 AM
|
|||
|
|||
creating 98 start up disk
-----Original Message----- Hello, My sytem.INI file is missing from my home cpu. I am using a network cpu to create a start up disk. It stops @ 20% and then says disk sector not found which I assume they are speaking of my floppy disk. Please help any instructions would be appreciated.. . Go to a working pc with 98 on it and open "add remove new programs" and create a start up disk. GUD Luck 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Start Vs. Restart | JD | General | 11 | July 7th 04 08:11 PM |
| Moving Unmovable Files with Norton Speed Disk | HKEK | General | 5 | June 26th 04 08:00 PM |
| notepad, disk defrag, disk cleanup missing | Norm Perry | General | 7 | June 23rd 04 07:18 PM |
| problems using a start up disk | Matthew Rosen Marsh | General | 2 | June 13th 04 11:13 AM |
| Start up after re format of hard drive | Sherry | Setup & Installation | 3 | May 31st 04 11:12 PM |
Linear Mode
