Thanks for your response:
But when I start the PC and push F10 to get in the Setup, I can see this
drive defined as primary slave with correct size 40960MB. Also If I use fdisk
under MS-DOS Promt, I can see this drive but with no letter.
This 40 GB drive worked fine in this machine before it crashed. Since I
already save a lot of files there, I hope I can save them without erase them
with HD installation program or fdisk.
"AlmostBob" wrote:
a pc with a 10GB original drive may be old enough that the BIOS cannot
support drives larger than (something (32GB?afair?)) if that is the case
then there was a drive overlay installed on the boot drive previously that
allowed the pc to access the 40GB, a drive larger than specified in the
bios. Goto the manufacturers web site of the 'unseen' drive and look for
drive overlays.
Maxtor produce MaxBlast,
WD produce DataLifeguard.
Read the instructions,
Read the instructions,
Read the instructions,
Ensure that this is the right solution before you do anything, check BIOS
settings drive types etc
it is possible to *expletive*deleted* the pc again if an overlay is
improperly installed.
--
-
Adaware http://www.lavasoft.de
spybot http://security.kolla.de
AVG free antivirus http://www.grisoft.com
Etrust/Vet/CA.online Antivirus scan
http://www3.ca.com/securityadvisor/virusinfo/scan.aspx
Panda online AntiVirus scan http://www.activescan.com
Panda online AntiSpyware Scan
http://www.pandasoftware.com/virus_info/spyware/test/
Catalog of removal tools (1)
http://www.pandasoftware.com/download/utilities/
Catalog of removal tools (2)
http://www3.ca.com/securityadvisor/n...aspx?CID=40387
Trouble Shooting guide to Windows http://mvps.org/winhelp2002/
Blocking Unwanted Parasites with a Hosts file
http://mvps.org/winhelp2002/hosts.htm
links provided as a courtesy, read all instructions on the pages before
use
Grateful thanks to the authors/webmasters
_
"Hua Wang" wrote in message
...
I have a PIII Windows 98 PC with two Hard Drives - 10 GB and 40 GB. The 10
GB
one used to store the software and 40 GB one store the files like photos
and
doc. For some reason the PC crashed and I had to reformat the 10 GB one
and
reinstalled the windows 98. However, after the installation, I can not see
the 40 GB one in My Computer. I can see it in the setup, and I can also
find
it named as 'Generic Disk' in the 'Disk Drives' under Control
Panel\System\Device Manager. But there is no letter assigned to it. And it
does not allow me to manually assign the letter. I have the Hard Drive
installation disk but it requires the erase of the disk. Is there any way
that I can bring back that disk without erase the files already in there?