Have you been running with the Quack?
Are you running Norton System Quack - - errr - Doctor?
If so, then read on......

You may have up to 32,000 empty OEM*.INF files sitting in your
c:\Windows\INF folder, which prevents any program putting a legitimate *.INF
file in there (it also slow your system down to stop, trying to read them
and sort the [non-existent] contents!).
You need to DELETE all 0byte (and ONLY the 0byte) OEM*.INF files.
look here for information on how to do that , and how to prevent it
happening again (i.e. TURN OFF NORTON SYSTEM DOCTOR - unless you are
actively troubleshooting something)

The Symantec site:
http://service1.symantec.com/SUPPORT...15010309&src=n

also
"Computer Stops Responding (Hangs) During Setup, Installing Updates, or
Adding New Hardware"
(http://support.microsoft.com/default...;en-us;Q281967)
also
http://support.microsoft.com/default...;en-us;Q301540
(which contains the fix for your problem in the NOTE under the patch
description)
Phone your Local MS office, and tell them your problem quoting Q301540 -
they'll either send you the patch, or give you a one-use password, for the
cost of the call.

Good Luck


--
Noel Paton (MS-MVP 2002-2004, Win9x)

Nil Carborundum Illegitemi
http://www.btinternet.com/~winnoel/millsrpch.htm

Please read http://dts-l.org/goodpost.htm on how to post messages to NG's
or
http://www.microsoft.com/presspass/f.../Mar27pmvp.asp
"THAGEN" wrote in message
...
WHEN I CONNECT A UPnP DEVICE TO MY COMPUTER, I GET THE
MESSAGE "UPDATING HARDWARE INFORMATION DATABASE - PLEASE
WAIT. i WAIT BUT NOTHING HAPPENS, AND WHEN I CHECK BY
USING CTRL-ATL-DEL THE MESSAGE I GET IS "UPDATING HARDWARE
INFORMATION DATABASE - NOT RESPONDING".
i HAVE TRIED MANY TIMES BUT ALWAYS GET THE SAME RESULT.
CAN SOMEONE PLEASE ADVISE?

THAGEN