Linksys BEFSR11 Router Configuration.
Hello,
Firmware 1.46.2 WinMe on a cable connection. One computer only.
Seven years after the purchase of my first system (including this router -
set-up by an acquaintance) I learn (via 'setup' in these forums and from a
post by Mike M) of an error in configuration.
This has left me with questions. Since I understand very very little about
networking/routers and their settings I am wondering whether there are other
errors in configuration.
Under Filters.
Filtered
Private IP Range: (0 to 254)
1: 192.168.1. ~
2: 192.168.1. ~
3: 192.168.1. ~
4: 192.168.1. ~
5: 192.168.1. ~
Filtered
Private Port Range:
(0 to 65535)
1: TCPUDPBoth ~
2: TCPUDPBoth ~
3: TCPUDPBoth ~
4: TCPUDPBoth ~
5: TCPUDPBoth ~
Block WAN Request: Enable
Multicast Pass Through: Enable
IPSec Pass Through: Enable
PPTP Pass Through: Enable
Remote Management: Disable Port: 8080
Remote Upgrade: Disable
MTU: Disable Size: 1500
Filter Internet NAT Redirection: Enable
Filter IDENT(port 113): Disable
Appreciate guidance on the above and, if deemed necessary, I will post with
the configurations of other pages.
Thank-you.
Ben.
|