Ok, well I can still fix it rite?

Also If the computer crashes, it wont recognise the slave
hd, unless I unplug the power from it then plug it back
in and reboot?

-----Original Message-----
Windows will report partitions not disks, so I would say
that you have
created a 30Gb partition on a 60Gb disk.

Do FDISK /Status in a DOS window to see the disk and
partition information.
--
Jeff Richards
MS MVP (DTS)
"sly" wrote in
message
...
tnx got it working, now one more thing. Its a 60 gb
hd,
but when I got to wondows it says that its only a 30 gb
drive.. Do you have any idea?
-----Original Message-----
If this is the cause of the problem, then you need to
set
the original disk
jumpers according to the manufacturer's instructions
for
a master with
slave. Without knowing what these are, it's not
possible
to be precise.
Some disk have a special setting for 'master with
slave',
others use the
same setting for 'master' and 'master with slave'.
--
Jeff Richards
MS MVP (DTS)
wrote in message
.. .
Ok, so I need to have my master also set to master,
cause
there are no jumper covers in the select for master
or
slave, its just the pins..



.



.