I know Easy CD Pro 95 is out of the Ark but it's been working fairly well -
until yesterday that is.

Now, when I try to launch the program I get the error code -

"SCSI Initialisation failed. In order to run this program you must have
WNASP132.DLL installed and started. (Code 220-11-00-00)"

My CD Burner, an old Memorex, isn't even a SCSI device and usually I get
something like "No Compatible CD Drive found on SCSI Bus," then I close and
restart the program and it detects the Memorex drive which is an ATAPI
device, say so, and away I go.

Since my SCSI scanner packed up all I've had on the SCSI bus is an old JAZ
drive that doesn't work either. Might deleting this and the SCSI card from
Device Manager and physically removing them help?

I've removed and re-installed Easy CD Pro of course but it's made no
difference.

I found WNASP132.DLL on my C drive and copied it to all likely locations,
Common Files, various System folders, the Easy CD Pro folder etc. but it's
made no difference. Any ideas would be most welcome.

I've since tried re-installing Windows 98, installing a new set of
downloaded ASPI files and also tried a LiteOn burner. The Nero software also
reported a file missing but only named it as ?.? A lot of help that
was! - not!

It seem what I really need to do is to find the correct location for the
WNASP132.DLL file and a way of making Easy CD Pro find it and run it. The
Registry comes to mind but all I've even done is edited it from time to
time. Adding whatever is necessary to achieve the above is beyond me.

The PC is a ten-year-old Dell Dimension XPS H226 running Windows 98SE.

Thanks in advance,

Nemo