Selections are as follows:
Select language, select custom install - driver only, install begins then
error message,exit setup, install recommences, another error message, exit
setup, install carries on with license agrrement, click accept and installing
driver progress bar goes to 100%, then after 5 - 10 seconds, error message
again, exit setup, screen reads congratulations you have successfully
installed etc,etc.

I have a scanner connected via USB (OK).

I have also loaded this software onto my laptop (Win 2000) with no problems
whatsoever.
--
gordon


"Mike M" wrote:

Again please if possible answer all my questions. So once again please:
a) What selections did you make at the start of the install?
b) Also do you have any other usb devices and if so do they work
correctly?

It is absolutely essential if you want others to try and help you to
provide complete answers as far as you can to their questions.
--
Mike Maltby MS-MVP



Gordon wrote:

The error message comes up at the start of the install. I click the
ignore button to carry on with the install but nothing happens. After
I close, the installation carries on with the same error occuring ( I
click ignore but it does not respond)
another two times, 26% through the install, then again at 100%. After
closing it says the installation was successful, which it wasnt --