It's a ps/2 scrolling mouse. I use to use the mouse with this computer before
the hard drive crashed and i replaced it. Since then i cannot plug it in
prior to startup. This computer is my brother's and he told me that it
crashed during a lightning storm and never ran again. When i got it back the
hard drive was broken (noisy and did not boot up) so i replaced the hard
drive and since then i cannot have the mouse plugged into it prior to start
up. But it works fine if i plug it in after start up. So for some reason it
has a problem loading it during start up. Again the twist is, if i tried
several different mice and this was the only one that made the computer
squirly (during start up) than i would determine that it is the mouse. But,
because two out of the three mice that i tried, two of them made it squirly I
am thinking that something with the drive or the port is the problem.

What do you think?

Thanks

"J. P. Gilliver (John)" wrote:

In message , Rich
newtech writes:
Now that i have the usb drivers corrected i think i will now take on the
mouse driver. When i look in the device manager the mouse port indicates that
it is working properly. However, when i plug an external mouse (one that i've
previously used with it) into the laptop prior to starting the pointer goes
wild and begins opening programs. Prior to me changing out the hard drive
this mouse worked perfectly fine with the computer. The twist is that if i
plug the mouse in after startup it works fine. Another thing to make this
strange is that i've tried two other mouses and one works ok when plugged
into the computer prior to startup. So two out of the three are squirly. Can
i remove the original drivers, plug the mouse in and reboot then install the
drivers that came with the mouse? Or should i just plug the mouse in after
startup?

Thanks in advance
Richard

Unless it has unusual functions, you shouldn't need a driver - assuming
it's a PS/2 mouse, anyway (those must be plugged in before windows
starts).

I'm not sure about USB mice. (If it's one that can be USB or PS/2, and
you have a suitable adapter, try it with the adapter. [Not all will work
with such an adapter.])

If it's a serial mouse - really old - it can be plugged in after Windows
has started, at least at the point where Windows says it can't find a
mouse. (Again, no driver should be needed.)
--
J. P. Gilliver. UMRA: 1960/1985 MB++G.5AL(+++)IS-P--Ch+(p)Ar+T[?]H+Sh0!:`)DNAf
** http://www.soft255.demon.co.uk/G6JPG-PC/JPGminPC.htm for ludicrously
outdated thoughts on PCs. **

WANTED, Dead AND Alive: Schrodinger's Cat