Marcy, I would suggest that you look here :-
http://h10025.www1.hp.com/ewfrf/wc/d...wareCategor y
and scroll down to about 2/3 down the page to the section :-
HP PSC 700 series ......... Win98, Me or 2000

It describes the method of installation 'slightly' differently to the way
you explained.

BTW - It might be useful to do a System Restore and roll-back to before you
first tried to install your all-in-one BUT do so AFTER you've uninstalled
the new software and BEFORE you re-install it again. In other words, during
Step 9 at the point where you remove the CD and before re-inserting it
again.

And, I ASS-U-ME that you are using the correct CD (The one designated for
WinMe)

If you still have problems then re-read the whole of the HP article -
there's an awful lot there!

Mart



"Marcy" wrote in message
...
Hi, I tried to in stall from the CD the softweaaare for my HP 750 series
all in one printer. Installation went good. I restarted the pc and then
plugged in my printer to the USB port then connected it to the
electricall outlet then that beige and green box popped up saying that if
I wanted to install the driver, etc..........It was checked under
recommended so it started to search and was no where to be found: Well it
said that it was unable to do it.I tried exploring the CD and it just
doesnt make a difference what I do it wont work. Isnt it true that after a
restart of an installation, set up continues and you may registrate every
thingand use the printer right away? WHy all this commotion with ME.
BTW, according to the HP instructions, printer is compatible with ME.
what can I do. thanks

--
Thanks so very much for your help-! ! ! !