"wilson23" wrote in message
...

i'm running windows 98se. upon starting up windows after the load screen,
my
monitor turns black and stays that way until i restart it. it will then
restart in safe mode a display box with 'desktop' at the top pops us
telling
me that "problem could be caused by your network or hardware settings.
make
sure these settings are correct in Control Panel and then try starting
windows again." when windows is loaded i am unable to change any settings
in
control panel under my display. however after restarting, windows loads in
normal mode, and then another display box pops up telling me that my
settings
need to be changed and the Control Panel pops up allowing me to change my
display settings. although when i try to change my display and restart my
computer the same thing happens each time no matter which setting i put it
on
it always goes back to 16 colors 640x480 pixels. display: super VGA
800x600
on diamond viper v770/ viper v770 ultra. any help would be greatly
appreciated, thanks!

Instal or reinstal the most up to date Win98SE driver
for your particular video card as displayed via
/ start / settings / control panel / system / device manager./ Display
adapters
Write down the filepath to the driver.

Method A is to remove all video drivers that appear and
reboot, hoping Windows will prompt you to instal it.
Method B is to use the /device manager / [exact name]
panel marked / Driver / Update.

Post results here.

--
Don Phillipson
Carlsbad Springs
(Ottawa, Canada)