View Single Post
  #14  
Old September 1st 04, 08:19 PM
Bert Kinney
external usenet poster
 
Posts: n/a
Default

Hi,

Sounds like a bad floppy drive.
Here are some steps to take for troubleshooting floppy drive problems.
1. Check to see if drive is unchecked in Tweakui.
2. Check system to make sure it is free of a Virus or Spyware.
3. If installed, turn off Dr. Solomon anti virus program.
4. Restart the computer. Hold CTRL while the system is booting.
Pick Command prompt only and test the drive. Type DIR and press enter.
You should see the directory tree.
5. Restart your computer by holding down the ctrl key and use the
"boot menu" to enter a safe mode windows session. Then in Device
Manager, locate and delete floppy drives *and* the floppy disk controllers.
Restart to see if Win98 re-detects properly.
6. If using a tape backup unit, remove/disconnect to see if
floppy function returns; if so, hunt for new tape drivers.
7. If using Norton Utilities, upgrade to 3.07 (or later, if
available) and/or disable Disk Doctor against the floppy drive.
8. Start | Run | msconfig | Selective startup | Un-select all
entries | restart | turn on one startup item, in turn, with restarts
between | when floppy ceases to function, you know the problem
is in the last file activated, so search and edit as needed.
9. CMOS settings are incorrect: write down all settings, then
re-set to defaults, restart to CMOS, re-enter the written down settings.
10. CMOS settings are incorrect: if "Swap Floppies" is enabled,
disable it.
11. Ribbon cables are 180 degrees out, or otherwise
mis-aligned/tilted: to correct, properly position connectors and
tracer color wire always to pin number 1 at both ends.

--
Regards,
Bert Kinney [MS-MVP DTS]
http://dts-l.org/
How to Configure Outlook Express for Internet News:
http://support.microsoft.com/default.aspx?kbid=171164

"DRIFT-O-MATIC" wrote

-----Original Message-----
Sounds like not a bootable (system) floppy.


I don't understand it. I downloaded several
bootdisks,and utilities from different sites, including
Maxtor. I followed the instructions for copying them to
floppy. However, whenever I boot to A:\ , I get
the "invalid system disk".