I ran the Fdisk /status command and here's the info it
gave:
Disk Drv Mbytes Free Usage
1 39206 1 100%
C: 39205
2 39080 100%
-----Original Message-----
"Brad L" wrote:
I was running two hard drives in my computer. The
primary
hard drive (c died. I replaced it, loaded Windows ME
again and the new drive seems to be working fine. It is
jumpered and cabled as the primary, master drive (like
the
one it replaced). I reconnected the second hard drive
and
it was detected by the bios but it does not show in
Windows. It is in the device manager as well but with
no
drive letter assigned to it. The secondary drive is
already formatted and partitioned with Fdisk from when I
initally installed it. I did not change the cabling or
jumper settings. How can I get Windows to assign a
drive
letter to the drive and make it accessable again?
Open a DOS command window and enter the following command:
FDISK /STATUS
That will tell you what is going on with regard to your
hard drives
and should give some clues as to what the actual problem
is. Post
the information back here if you need further advice or
assistance.
Note: If you modify the command to read:
FDISK /STATUS C:\DISK.TXT
then the output will be saved in the file c:\disk.txt
which you can
open in Notepad and then copy and paste the reported data
into a reply
back here. DO NOT ATTACH THE DISK.TXT FILE TO A REPLY.
Good luck
Ron Martell Duncan B.C. Canada
--
Microsoft MVP
On-Line Help Computer Service
http://onlinehelp.bc.ca
"The reason computer chips are so small is computers
don't eat much."
.