|
|
win98 vs win98se by
dawilknsn
I am wanting to upgrade from windows95 to windows98. Which would be the best
one to upgraade to windows98 or windows98se? I am assuming the SE stands for
Second Edition.
|
|
5 |
1,460 |
|
|
Only boot from cd rom by
annie
A friend has this old pc with win 98. It will only boot with the win 98 cd in the rom.
I tried every combination of boot sequence in the bios, the only 2 that will get the thing going is c, cd rom or cd rom , c. A menu will then come up asking to boot from hard drive or cd rom.
I choose hard...
|
July 24th 05 04:05 PM
by glee
|
2 |
1,118 |
|
|
Network Neighborhood - Adding Service by
Zel Dolinsky
First thank you very much for trying to help out.
Although I am going to talk about DCC the issue is actually very much
simpler per below.
I am trying to use Direct-Cable-Connection (DCC) which I have successfully
done before using other computers. I seem to be getting stuck at a very
simple...
|
|
2 |
1,326 |
|
|
need to remove "Network" from Win98SE to use Outlook by
Elle
Computer was not working well so I reformatted the hard drive. When I
re-installed Win98SE I intended to connect two computers, so I said it would
be a network. Now I don't want to use the second computer. Problem: Outlook
(Office 2000) will not open. Message: must connect to your...
|
July 23rd 05 05:45 PM
by Elle
|
2 |
1,041 |
|
|
Windows 98 New Hard drive install by
OceanmindedLiz
Hey all. I just reformatted my computer. And it's a little old, Gateway 2000.
I'm trying to reinstall Windows 98 2nd edition but I can't. It's the upgrade
disk and I have to have another OS on the computer I think. Is there any way
someone can help me? Should I install 95 and try to upgrade from...
|
|
2 |
1,190 |
|
|
Computer Hangs On Verifyinf DMI Pool Data by
standing_guitar
I've been tackling this problem for a while now and I'm completely out of
ideas.
I know this is hardware related for sure, because when I turn on my
computer, it does the memory test fine, detects all the drives fine...but,
when I reach 'Verifying DMI Pool Data' it just stops. There is no...
|
July 23rd 05 04:04 AM
by glee
|
2 |
1,269 |
|
|
Boot problem by
ronbo76
Hello,
Today I was given a computer that would only boot in SAFE mode. I ran all
the recommended trouble shooting modes (suggested in the Help file). I came
to one that had me type the following commands:
c:\windows\command\attrib -h -s -r c:\system.1st
c:\windows\command\attrib -h -s -r...
|
|
7 |
1,292 |
|
|
Find doesn't show file path by
Capthzm
All of a sudden when I do a find search- it will find the file- the
size-date-type-but it doesn't tell you where it is at- the column is there-
it's just blank-anyone know how to restore it-thank -Jay
|
|
2 |
1,031 |
|
|
Fixing USB by
Andrew Chalk
My Samsung ML-1710 USB connected laser printer driver installed fine. The
printer is shown as "ready". However, whenever I try and print anything it
fails with a "USB error" (no details).
Is there a straightforward way to reinstall USB on Win98SE?
Anyone else have this problem and know how to...
|
|
2 |
1,148 |
|
|
Setting up Windows98 by
joshb
Hi guys,
I'm currently working on a 133mhz computer which I'm trying to get up
just so someone in the family can have something to listen to.
Basically, here's my problem:
I used the Win98 Boot Disk from www.bootdisk.com, used FDISK to delete
the current active partition and then remade a new...
|
|
9 |
1,386 |
|
|
Product Key 98/reinstalling/regedit? by
Bruce
I need to clean a HD off, they can't find the book,
they do have a legal copy of 98, which goes to this computer.
I know you can find the key by searching regedit,
what would it be under?
|
|
1 |
1,089 |
|
|
Can't load the DLL library by
merkinp
I recently put a new HDD in an old computer and
replaced the W98SE OS. I had saved the drivers
and got the system operating again without too much
trouble. However, when I tried to load some ATT dial-up
connection software I got the message "Cannot load the
DLL library D:\WINCLIENT\wisehlp.dll". I...
|
July 19th 05 01:11 PM
by philo
|
2 |
1,326 |
|
|
Parallel Port Issues by
[email protected]
Hello all, I am having a problem that I have never seen before.
I have a pc that has onboard printer port. This is defaulted to lpt1.
I installed another parallel card in the machine, but it pops up as
lpt3. Leaving lpt2 missing. I have tried to go into the registry and
rename lpt3 to lpt2,...
|
|
5 |
1,066 |
|
|
Dial-up netwroking is missing by
Steve
My friend just bought a second-hand PC from the IT department at his
workplace. It has Windows 98 (not SE) and has always been used on a
network. I bought a 56k PCI modem and installed it OK, but dial-up
networking on the machine is missing. Going into add/remove programs and
clicking on the...
|
July 18th 05 06:38 AM
by Steve
|
2 |
1,010 |
|
|
Drivers--Where are they? by
Joe McGuire
Help! My Compaq notebook (Win98SE) seems to be demanding certain drivers
(or the non-existent Win98SE CD) while booting up after reinstalling a
Wireless adapter which used to work pretty well until recently. The
computer cannot find these files anywhere I can think of,...
|
July 17th 05 01:37 AM
by PattyL
|
7 |
810 |
|
|
Can't Install Win98 by
Nospam
I just replaced a crashed hard drive in a circa 2000 Compaq Presario
desktop. Now I can't get Windows 98 to install. I would upgrade to
either Win2000 or XP, but Compaq offers no video drivers for anything
but Win98.
The problem is that I can't get the CD-ROM drive to boot the Win 98
CD. It will...
|
|
1 |
1,140 |
|
|
Win 98 will not boot by
adamsean007
I have been working on my friends Compaq Presario 5712, which is dead in the
water. I am unable to boot it in normal or safe mode. I receive to error
messages, one is a security message and the other is a explorer message. The
ezplorer message = "This program has performed an illegal operation...
|
|
8 |
1,278 |
|
|
Windows 98 install problems by
Jmach1
hi. i am having some serious problems reinstalling windows 98. at first it
was the hard drive(it failed) but i got a new one and i still can't install
windows without receiving all kinds of error messages. for example, when i
get to the part where i enter my key, an error message pops up...
|
|
1 |
1,185 |
|
|
Drive A: by
rmpete
Is there any way I can get my USB Floppy Drive to become drive A: so I can
make a startup floppy disk in Windows 98?
Thanks
|
|
4 |
1,193 |
|
|
Win98SE boot problem by
AMW
Hello all
Having a problem with windows freezing on startup. I believe it almost gets
to the
desktop before it stops. I can get into safe mode. Here's what I've tried so
far;
Virus scan
spyware scan
turn off graphic card hardware acceleration
in msconfig I unchecked all startup items
|
|
1 |
1,330 |